Client Quality of Service
Class Map
Cisco WAP571/E Administration Guide 128
8
• Class Map Name—Choose the MAC class map from the list.
• Match Every Packet—When enabled, all Layer 2 packets will match the
condition.
• EtherType—Compares the match criteria against the value in the header of
an Ethernet frame. Choose an EtherType keyword or enter an EtherType
value to specify the match criteria:
- Select from List—Matches the Ethertype in the datagram header with
the selected protocol types: appletalk, arp, ipv4, ipv6, ipx, netbios,
pppoe.
- Match to Value—Matches the Ethertype in the datagram header with a
custom protocol identifier that you specify. The value can be a four-digit
hexadecimal number in the range of 0600 to FFFF.
• Class of Service—Specifies the class of service 802.1p user priority value
to be matched for the packets. The valid range is from 0 to 7.
• Source MAC—Includes a source MAC address in the match condition for
the rule.
- Source MAC Address—Enter the source MAC address to compare
against an Ethernet frame.
- Source MAC Mask—Enter the source MAC address mask specifying
which bits in the destination MAC address to compare against an
Ethernet frame.
For each bit position in the MAC mask, a 0 indicates that the corresponding
address bit is significant and a 1 indicates that the address bit is ignored. For
example, to check only the first four octets of a MAC address, a MAC mask of
00:00:00:00:ff:ff is used. A MAC mask of 00:00:00:00:00:00 checks all address bits
and is used to match a single
MAC address.
• Destination MAC—Includes a destination MAC address in the match
condition for the rule.
- Destination MAC Address—Enter the destination MAC address to
compare against an Ethernet frame.
- Destination MAC Mask—Enter the destination MAC address mask
specifying which bits in the destination MAC address to compare against
an Ethernet frame.
To Next Page
Loading...
Need help?
General
