Cisco WAP100 Series Administration Guide

SNMP
Users
Cisco WAP571/E Administration Guide 152
10
STEP 1 Select SNMP > Users in the navigation pane.
STEP 2 Click Add to create a new row in the SNMPv3 Users table.
STEP 3 Check the box in the new row and click Edit.
STEP 4 Configure the parameters:
• User Name—A name that identifies the SNMPv3 user. User names can
contain up to 32 alphanumeric characters.
• Group—The group that the user is mapped to. The default groups are RW
and RO. You can define additional groups on the SNMP Groups page.
• Authentication Type—The type of authentication to use on SNMPv3
requests from the user, which can be one of these options:
- MD5—Require MD5 authentication on SNMP requests from the user.
- None—SNMPv3 requests from this user require no authentication.
• Authentication Pass Phrase—(If you specify MD5 as the Authentication
Type) A pass phrase to enable the SNMP agent to authenticate requests
sent by the user. The pass phrase must be between 8 and 32 characters in
length.
• Encryption Type—The type of privacy to use on SNMP requests from the
user, which can be one of these options:
- DES—Use DES encryption on SNMPv3 requests from the user.
- None—SNMPv3 requests from this user require no privacy.
• Encryption Pass Phrase—(If you specify DES as the privacy type) A pass
phrase to use to encrypt the SNMP requests. The pass phrase must be
between 8 and 32 characters in length.
STEP 5 Click Save. The user is added to the SNMPv3 Users list and your changes are
saved to the Startup Configuration.
NOTE To remove a user, select the user in the list and click Delete.

Cisco WAP100 Series Specifications

General

Brand	Cisco
Model	WAP100 Series
Category	Wireless Access Point
Language	English