To Next Page

To Previous Page

6 Tempest®900 4-Channel Wireless Intercom System

Quick Start Guide

What You Will Need

BaseStaon

» Power cord

» One BaseStaon antenna

» 3.5mm male-to-male mini-stereo

pairing cable

BeltStaons

» Up to 5 per BaseStaon

» Lithium-Polymer baery and

» Charger - 1 per BeltStaon

Headsets (customer supplied)

» 1 per BeltStaon

» 1 per BaseStaon

1. Connect a whip antenna onto the back of the BaseStaon.

Select a suitable locaon for the BaseStaon. Tempest is a radio system, broadcasng and receiving RF signals that are

aected by physical and electronic barriers.

The antenna should be located as high as possible and away from all

obstrucons. When using whip (omnidireconal) antenna, select a locaon

as close as possible to the center of the area you want to cover.

Use alternave antenna opons when the BaseStaon is in a rack or other

metal structure, or stacked with other gear. Remote locaon antenna

placement of up to 1,500 . can be achieved using the Tempest Remote

Transceiver (part # CCT-9RT). See the user manual for more details about

antenna placement, recommended cable types, and other antenna opons.

2. Connect the power cord and Power On the BaseStaon.

3. Install Baeries in BeltStaons

Install the Lithium-Polymer baery in each BeltStaon. Be certain that the gold

contacts on the baery touch the contacts in the baery compartment. The baery

is shipped with a paral charge, so charging will be necessary before maximum run

me will be achieved.

Insert (3) AA alkaline baeries in the baery compartment. Always replace the

baery cover.

To power ON the BeltStaon, press and hold the power buon for approximately

two seconds. The display will indicate “None Selected.” Turn the power OFF by

holding the power buon for four seconds.

Clear-Com Tempest 900 Reference Manual

Other manuals for Clear-Com Tempest 900