EasyManuals Logo

Clear-Com Tempest 900 Reference Manual

Clear-Com Tempest 900
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
40 Tempest®900 4-Channel Wireless Intercom System
BeltStaon Setup
Steps to Setup the BeltStaons
Install the baery.
“Pair” BeltStaons to the BaseStaon.
Adjust slot sengs as needed.
Connect a headset.
Adjust Mic Gain.
Adjust Sidetone.
Congure oponal features:
» Name the BeltStaon.
» Disable unused funcons, channels, and buons.
» Select/disable relay opons as needed.
» Adjust personal preferences.
Baery Selecon and Installaon
The Tempest BeltStaon Baery Compartment holds either one Tempest Lithium-Polymer rechargeable baery or three
standard alkaline AA cells. Lithium-Polymer baeries are the primary power source. High quality alkaline AA cells may be
used in situaons where Lithium-Polymer baeries are not available or are not charged. One Lithium-Polymer baery
comes standard with each Tempest BeltStaon. Addional Lithium-Polymer baeries may be purchased. Contact your
dealer or distributor to purchase addional baeries. The Lithium-Polymer baeries supplied with your Tempest Wireless
system are warranted for 12 months from the date of purchase.
Lithium-Polymer baeries oer up to nine hours of baery life and recharge in
approximately 2¾ hours.
Lithium-Polymer baeries ship from the factory with approximately 50% charge. It
will not damage the Lithium-Polymer baeries to use them without charging them
rst. This will, however result in shorter run me unl the Lithium-Polymer baery
is fully charged. When possible, charge Lithium-Polymer baeries to full capacity to
ensure full baery life prior to use.
Using (3) alkaline AA baeries can provide up to four hours of baery life. Use
only high quality alkaline AA cells. This will provide enough me to fully charge the
Lithium-Polymer baery.
To remove the baery door, press down on the thumb markings and pull the baery door toward the boom of the
BeltStaon.
To remove baeries from the baery compartment, turn the BeltStaon baery side down and tap the boom of the
BeltStaon on the palm of your other hand.
Please be careful to insert alkaline AA baeries according to the marked polarity. All of the alkaline AA cells must be
oriented the same direcon.
If the baery cover does not close properly, the baery may not be inserted correctly.

Table of Contents

Other manuals for Clear-Com Tempest 900

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clear-Com Tempest 900 and is the answer not in the manual?

Clear-Com Tempest 900 Specifications

General IconGeneral
BrandClear-Com
ModelTempest 900
CategoryIntercom System
LanguageEnglish

Related product manuals