EasyManua.ls Logo

Clear-Com Tempest 900 - Front Panel Lock

Clear-Com Tempest 900
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35 Tempest®900 4-Channel Wireless Intercom System
Front Panel Lock
The Front Panel Lock funcon is intended to minimize the probability of unintenonal adjustments to the system. Press
MENU, select “BaseStaon Sengs,” scroll and select “Front Panel Lock,” press 1 or ENT to select Lock. Press MENU to exit
to the main Operaonal screen. The buons and knobs on the front of the BaseStaon will not funcon unl unlocked,
except for the power switch which will power the unit OFF. When the BaseStaon is powered ON, it is always unlocked.
Press MENU + ENTER to unlock.
Call Funcon
On the BaseStaon front panel, select a channel by pressing the Volume control. Press and hold CALL for as long as you
want the Call signal to go out on the channel.
A Call signal will be received by users who are listening on the channel that originated the Call signal.
Stage Announce (SA)
The Stage Announce (SA) funcon in the Tempest BaseStaon is used to send a wireless BeltStaon microphone signal to
a dedicated external audio output. When a wireless user presses the STAGE buon on the BeltStaon, their audio is re-
routed from the selected intercom channel(s) and is sent to the BaseStaon rear panel SA connector. In addion, a relay
closure contact is available on the RELAY connector on the back of the BaseStaon. Pressing the STAGE buon enables the
headset microphone, regardless of the status of the Talk buons. If enabled, all BeltStaons can access this feature.
The Stage Announce output connector is an XLR-3M. The Stage Announce connector is balanced and transformer isolated
and outputs nominal line level audio from -12 to +12 dBu. The Stage Announce connector output level can be adjusted at
the “Stage Announce” menu screen, under “Wired Intercom Sengs.
In addion, the Stage buon may be congured to also control an addional relay assigned to the users BeltStaon. See
the GPO Relay secon for more details.
On the BaseStaon, an acve Talk buon is not required to send a Call signal, and
the Call signal is routed to the channel selected for monitoring. On the BeltStaon, a
Call signal is sent only when the Talk buon is enabled, and only on the channel(s)
selected for Talk.

Table of Contents

Other manuals for Clear-Com Tempest 900

Related product manuals