Clear-Com Tempest 900 - How Do I; Remove Batteries from Beltstations; Install the Rechargeable Battery; Charge the Battery

64 Tempest®900 4-Channel Wireless Intercom System
How Do I …?
Remove Baeries from BeltStaons
Remove the baery cover from the back of the BeltStaon by pressing lightly on the thumb grooves and sliding
towards the boom. Hold the BeltStaon in one hand with the baery compartment facing downward over the open
palm of your other hand. Firmly tap the BeltStaon against the palm of your open hand and the baery will fall into
your open hand. Follow the same procedure for AA baeries.
Install the Rechargeable Baery
The gold baery contacts must mate with the contacts in the baery compartment. If the baery is not properly
seated, the cover will not close easily.
Charge the Baery
Connect the plug-in baery charger (included with BeltStaon) to a standard wall outlet and to the Mini-USB
connector on the BeltStaon. This connector is located under the rubberized access cover on the side of the
BeltStaon. The baeries will charge from completely empty to a full charge in about 2¾ hours. The baeries will not
overcharge. The BeltStaon remains funconal during charging.
Install AA Alkaline Baeries
Remove the baery cover on back of BeltStaon. Insert (3) AA alkaline baeries according to the polarizaon shown
inside the baery compartment. Replace the baery cover. All baeries install with the posive terminal toward the
side with Mini-USB charger connector.
Use the 5-Bay Baery Charger
Plug charger into local AC power source and place up to ve rechargeable, Lithium-Polymer baeries into the
charger. Charging is complete when the indicator turns green. Re-charge me is 2½ hours and the charge provides
approximately nine hours of operaon
Navigate the BaseStaon Menu
Press MENU to open the Main Menu. MENU also funcons as an Escape key. Turn the Volume control to scroll
through the menu. To select, press ENT or press the Volume control. The keys numbered 1 through 5 under the LCD
screen take you directly to the corresponding BeltStaon menu. If no entry is made within 3 minutes, the display will
automacally return to the Operaon Screen.
Navigate the BeltStaon Menu
Press MENU to open the Main Menu. MENU also funcons as an Escape key. Turn the Volume control to scroll
through the menu. To select, press ENT or press the Volume control. If no entry is made within a few seconds, the
display will automacally return to the Operaon Screen.