To Next Page

To Previous Page

67 Tempest®900 4-Channel Wireless Intercom System

Update the Firmware (with CodeUpdater)

Tempest rmware updates are released periodically,

and equipment should be updated to maximize

opmal system performance. Staying up to

date with the latest rmware ensures that your

system is equipped with the newest features and

enhancements that Tempest has to oer.

Tempest uses a proprietary program, CodeUpdater,

to update rmware in the BaseStaon and the

BeltStaon. Tempest CodeUpdater can automacally

detect what rmware is currently installed on a unit

and indicate whether a later version is available. Note:

You must have internet access on your PC for CodeUpdater to

accurately detect the latest released versions available.

Connecng Your BeltStaon for Updang:

• Be sure the BeltStaon is powered OFF.

• Plug in your USB programming cable to your computer rst.

• Push and hold the CALL buon on the front of the BeltStaon and plug in the USB cable to the side USB-A

connector on the BeltStaon. The BeltStaon will power ON automacally. Do not release the CALL buon unl

the BeltStaon display message appears.

Connecng Your BaseStaon for Updang:

• Be sure the BaseStaon is powered OFF.

• Plug in your USB programming cable to your computer and into the front USB-B on the BaseStaon.

• Push and hold the MIC KILL buon on the BaseStaon front panel and then power ON. Do not release the MIC

KILL buon unl the BaseStaon display message appears.

Updang Firmware:

• Open Tempest CodeUpdater on your PC.

• Connect the device. CodeUpdater will list the model of the equipment connected next to device.

• You may be prompted to update Bootloader rmware. If so, it is highly recommended that you do update it.

When updang the Bootloader, it is very important that you not interrupt the update. Be sure USB cable is

securely connected before starng the upgrade process. Interrupng the update may require the device to be

returned to the factory for re-programming. It is highly recommended that you not use a wireless connecon

when updang the bootloader. Note: If you update the Bootloader you will have to re-connect your device to inialize the

process again.

• The “Current Version” of rmware will display in CodeUpdater along with the “Latest Version” available (if

applicable). Note: The PIC rmware version is only applicable to the BaseStaon rmware.

• If an update is available check the box under “Upgrade Selecon” and click the <Upgrade> buon.

• Repeat these steps as needed for each Tempest unit.

Clear-Com Tempest 900 Reference Manual

Other manuals for Clear-Com Tempest 900