Clear-Com Tempest 900 Reference Manual

65 Tempest®900 4-Channel Wireless Intercom System
Adjust Min/Max BeltStaon Volume Levels
From the BeltStaon:
• To set the Minimum volume, press MENU, select “Set Controls,” then “Volume Limit” and “Min Volume.” Use
the Volume knob to adjust the level and press ENTER to save the new seng.
• To set the Maximum volume, advance to “Volume Limit” as above, and then “Max Volume.” Use the Volume
knob to adjust the level and press ENTER to save the new seng.
From the BaseStaon:
• Select the number key 1 through 5 that corresponds to the BeltStaon desired and select “Volume Limit.”
• To set the Minimum volume seng, select “Min Volume.” Use the Volume/Scroll knob to adjust the level and
press ENTER to save.
• To set the Maximum volume seng, select “Max Volume.” Use the Volume/Scroll knob to adjust the level and
press ENTER to save.
Congure Stage Announce and SA Relay
From the BeltStaon:
• To set Stage Announce, press MENU; select “Set Controls;” select “Stage Announce;” select “Momentary.” This is
the default seng.
• To set SA Relay, press MENU; select “Set Controls;” select “Stage Announce;” Select “SA Relay Enable.” This is the
default seng.
From the BaseStaon:
• To set Stage Announce, select the numbered key 1 through 5 that corresponds to the BeltStaon desired.
• Select “Stage Announce,” select “S/A Audio,” select Momentary.
• Press MENU to go up one level in the menu.
• Select “Stage Announce” to set “SA Relay” and select SA Relay Enable.
• The STAGE buon is always Momentary when enabled.

Clear-Com Tempest 900 Specifications

General

Brand	Clear-Com
Model	Tempest 900
Category	Intercom System
Language	English