Clear-Com Tempest 900 - Page 27

21 Tempest®900 4-Channel Wireless Intercom System
Talk Buon A/B and C/D
There are two TALK buons on each BeltStaon, one for
channels A/B and the other for channels C/D. The Talk buon
enables the microphone signal for the assigned intercom
channels.
Tempest uses an intelligent latching method for TALK buons.
Pressing the TALK buon momentarily will cause the TALK
buon to latch. Pressing and holding the TALK buon will
cause the buon to act as a momentary switch.
Talk tones can be enabled or disabled per BeltStaon. If
enabled, users will here a tone each me the TALK buon is
pressed.
Channel Indicator LEDs A/B and C/D
Each Talk buon has four individual LED indicators. Together they surround the
Talk buon. The LEDs will ash blue to indicate which intercom channel, A, B, C,
or D, has been selected and will illuminate connuously to indicate that “Talk”
is enabled on that channel.
The Channel Indicator LEDs will ash red when the microphone signal is reaching
a peak level and is entering into liming.