Clear-Com Tempest 900 - Page 75

69 Tempest®900 4-Channel Wireless Intercom System
No audio passing when not using an external hard wired intercom system and Tempest BaseStaons are
sharing intercom channels.
• Conrm that no wired intercoms are connected to the system.
• Conrm a 3-pin XLR cable connecon for each channel to be shared, between each of the BaseStaons.
• Set the BaseStaon 2-Wire Intercom Type Select Switches to the Clear-Com posion.
• Select 2-Wire for the relevant channels. Set only one of the Tempest BaseStaons to Master Mode.
No audio passing when using an external hard wired intercom system and Tempest BaseStaons are
sharing intercom channels.
• Conrm a 3-pin XLR cable connecon for each channel to be shared, between each of the BaseStaons.
• Set the BaseStaon 2-Wire Intercom Type Select Switches to the appropriate posion.
• Select 2-Wire for the relevant channels.
• For each channel to be shared, connect the wired intercom to one of the BaseStaons.
Audio can only be passed from one BaseStaon to another in the “Clear-Com mode”
unless actually connected to to another type of wired intercom system. Connecng
any wired intercom to any BaseStaon will automacally disable Master Mode and
disconnect all shared channels that do not have a wired intercom connected.
When connecng any shared BaseStaons to any wired intercom system, only
channels connected to the wired system can be shared.