Chapter 3: Operate the system
36 Use a phone or fax machine
In the web interface you can set up which type of connection to use when
you make or receive a call from the Phone/Fax or ISDN interface or from an
IP handset connected to the LAN interface.
Example: If you always have a fax connected to the same Phone/Fax
interface you can set this interface to 3.1 kHz Audio only. This
will mean that if an incoming Standard Voice call is received,
this Phone/Fax interface will not ring. For details how to set up
the interfaces see the AVIATOR 200/300/350 Installation and
maintenance manual.
When connecting a G4 fax or a modem to the ISDN interface in the system
you must use UDI.
To select the default outgoing call type
This is typically set up during initial configuration of the system.
You can set the default outgoing call type in the web interface. To select the
default call type for outgoing calls, do as follows:
• For ISDN: Select the call type in the web interface under SETTINGS >
ISDN.
For further information, see the AVIATOR 200/300/350 Installation and
maintenance manual.
• For Phone/Fax:. Select the call type for each port in the web interface
under SETTINGS > Phone/Fax. For further information, see the
AVIATOR 200/300/350 Installation and maintenance manual.
To override the default outgoing call type
To override the default setting for a specific outgoing call, do as follows:
•To use Standard Voice for the call, dial 1* before the number.
•To use 3.1 kHz Audio for the call, dial 2* before the number.
Modem or fax: When connecting a fax or a modem to the
Phone/Fax interface you must use 3.1 kHz Audio.
To Next Page
Loading...
