Installation check list: Functional test in harbor
98-175666-A Chapter 5: Installation check lists 5-3
5.3 Installation check list: Functional test in harbor
Step Task Further information Done
1.
Check that the antenna is tracking
the satellite
The logon LED in the BDU display
must be steady green and the display
shows: TRACKING.
In the web interface top bar check
that the system status shows
Tracking
2.
Check that the VSAT modem is in
lock and ready for Tx.
In the web interface Dashboard on
modem card check RX frequency and
signal level shows values.
3.
Connect a user PC LAN (not the
service PC) to the Internet LAN
connector of the VSAT system.
Check the VSAT modem
documentation for details.
4.
Make sure that the computer has
no access to the Internet through
other means (Wifi, 3G, 4G etc.).
Open a command prompt and type:
ping 4.2.2.2.
Check that you get a response.
5.
Make sure that the computer has
no access to the Internet through
other means (Wifi, 3G, 4G etc.).
Open a web browser and browse to
e.g. www.google.com.
Check that the web page is
downloaded.
6.
If step 4 is successful and step 5 is
not then it seems like the DNS is
not configured correctly.
Check the VSAT modem
documentation how to set up the
DNS server, “Obtain DNS server
address automatically” or enter
specific DNS server addresses.
Table 5-3: Installation check list: Functional test in harbor
To Next Page
Loading...
Need help?
General