Service
98-175666-A Chapter 4: Setup of the antenna 4-33
6. Click Start. One Touch Commissioning takes place. When commissioning is completed
the antenna will search for the I5 satellite with the highest elevation.
7. The antenna will find the satellite and the modem will perform the necessary steps to
enter the network (software upgrades, if available).
8. The web interface of the iDirect core module will indicate the modem in the network
and the modem status is shown in the display in the menu MODEM of the SAILOR XTR
Ka web interface.
9. When commissioning is completed, test all subscribed services.
10. Exit the iDirect web interface.
4.3.4 Modem access configuration (port forwarding)
For ease-of-use, you can access the modem (e.g. modem web interface) through the BDU
using port forwarding. To make the modem accessible via the BDU, do as follows:
1. In the BDU web interface, select Service > Modem.
2. Select one of the following methods to access the modem.
• HTTP tunnel to modem (port 8080)
• HTTPS tunnel to modem (port 8443)
• SSH tunnel to modem (port 8022)
• Optional tunnel target IP address (blank to disable)
3. Click Apply.
Example: To access the web interface of your modem using HTTPS, select HTTPS
tunnel to modem (port 8443) and click Apply.
Then, in the address bar of your browser, enter:
https://<BDU IP address or hostname>:8443
You should now see the web interface of the modem.
4.3.5 Line up
The SAILOR XTR Ka has been tested at the factory and online on a live satellite link to
calibrate the TX polarization unit. You can fine-tune the TX polarization by doing a line up.
For Ku terminals, you must always enter the modem IP address here, it cannot
be left blank.
To Next Page
Loading...
Need help?
General