98-175666-A Appendix D: Command line interface D-2
List of commands
Access to the SAILOR VSAT system system is protected by a user name and password. This
is the same user name and password that is used in the web interface under
ADMINISTRATION.
The interface is on the standard Telnet port 23 or SSH port 22. Use any LAN port and
corresponding IP address of the BDU (except LAN 2 on GX/Ka BDU). To start telnet session
do as follows:
1. Open a Telnet client of your choice.
2. At the prompt, enter the IP address of the BDU, login admin and password.
Help
If you enter help directly at the prompt UCLI:/$ all available commands are listed.
Additionally any command will take help as first argument and display detailed
information of the specific command.
Conventions
The command description below uses the following special typography:
Example: navigation heading [mode [value]]
D.2 List of commands
The following commands are described in detail. They are listed in alphabetical order.
• antenna_data
• calib
• config
• demo
• dual_antenna (not supported yet)
• exit
Figure D-3: Command line interface, login
Convention Description
Courier font Information that is displayed on the screen.
Bold Courier font Text the user must enter.
<argument> Required argument
[argument] Optional argument
Table D-1: Command typography
To Next Page
Loading...
Need help?
General