98-175666-A Appendix D: Command line interface D-4
List of commands
D.2.4 demo
D.2.5 dual_antenna (not supported yet)
D.2.6 exit
D.2.7 help
Command Description
demo
Shows detailed information of this specific command.
demo start
Starts a demo pattern where the antenna will turn azimuth,
elevation and cross elevation until it receives the command
demo stop.
demo stop
Stops the antenna demo pattern.
demo reset
Resets the antenna to angle 0.
Table D-5: UCLI command: demo
Command Description
dual_antenna mode
Shows the current dual antenna mode
•single
•master
•slave
dual_antenna status
• Shows the current dual-antenna mode status
•active
•inactive
Table D-6: UCLI command: dual_antenna
Command Description
exit
Exits the connection to the SAILOR XTR Ka.
Table D-7: UCLI command: exit
Command Description
help
Shows detailed information of this specific command.
help status
Shows the sub commands and description for the command
status.
help system
Shows the sub commands and a short description for the
command system.
help config
Shows the sub commands, unit and description for the
command config.
Table D-8: UCLI command: help
To Next Page
Loading...
Need help?
General