Startup sequence
98-175666-A Chapter 4: Setup of the antenna 4-40
Example: EVENT 1/4*: This is the first event out of a list of 4 and there has been a
change in the list. EVENT 1/4 will always be shown, the * indicates that there
has been a change.
4.5 Startup sequence
Once the system is configured and a VSAT profile is active, the startup sequence is as
follows:
• Antenna POST pending
• Antenna SW upload (If the software versions in the ADU and BDU are not the same,
a software update is done during startup.)
• Antenna POST
•Ready
•Acquiring Signal
•Tracking
When the display shows TRACKING and the LED Logon is steady green, the system is
operational.
To Next Page
Loading...
Need help?
General