Operating the transceiver
82 2110 SSB Transceiver Reference Manual
The transceiver will respond with two high short beeps and displays Go Secure,
the Secure Mode and Secure Key used, and PIN to indicate that a PIN is in use. For
example:
If you are in the Channel List, the active voice encryptor is indicated by the word
Secure<C|G>P highlighted at the left of the channel screen. For example:
Switching between Global and Corporate Modes
Whenever you switch on the voice encryptor it will enter the mode that is set in the
Secure Mode entry in the Control List. For help on setting the default Secure Mode see
page 96, Changing a setting in the Control List and page 200, Entries in the Control List.
To switch between the Global and Corporate Modes while using the voice encryptor:
1 Hold SEC.
1 Use or to toggle between Global and Corporate.
1 If you want to use a PIN, enter the 4-digit PIN that you have agreed to use with
others for this session.
1 Press .
NOTE
The default Secure Mode is not changed. Next time you switch on the
voice encryptor, the default mode will be entered.
To Next Page
Loading...
Need help?
General
