COMPLIANCE
EMC AND SAFETY NOTICES
Envoy™ Transceiver Getting Started Guide 97
EMC
CAUTION: If it is necessary to remove the covers at any
stage, they must be refitted correctly before using
the equipment.
To ensure that compliance with the EMC Directive is maintained.
1 Use standard shielded cables supplied from Codan (where
applicable).
1 Ensure the covers for the equipment are fitted correctly.
1 Cover unused connectors on the RF unit with the protective
caps supplied to prevent electrostatic discharge passing
through your transceiver.
Electrical safety
To ensure compliance with the European Low Voltage Directive is
maintained, you must install and use the Envoy™ Transceiver in
accordance with the instructions in the Envoy™ Transceiver
Getting Started Guide and the Envoy™ Transceiver Reference
Manual.
When using equipment that is connected directly to the AC mains
these precautions must be followed and checked before applying an
AC main supply to the unit.
To Next Page
Loading...
Need help?
General
