OPERATING THE TRANSCEIVER
SCANNING CHANNELS
52 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Scanning channels
If you intend to receive calls on several channel/modes, switch on
scanning. When scanning is switched on, the transceiver
sequentially selects each channel/mode in your HF network to
detect incoming calls. The channel/modes are scanned in a
continuous cycle. Mute is switched on automatically.
When the transceiver detects a call addressed to your station, it
stops scanning and notifies you according to the type of call
received. When you press SCAN to end the call, scanning resumes.
If you do not press this key to end the call, or any other key within
a pre-determined timeout, the transceiver automatically ends the
call and resumes scanning.
When the transceiver detects voice, it notifies you according to the
mute setting selected. If your transceiver is set to notify you when
voice is detected, you can pause scanning, select the channel/mode
on which the voice was heard, then resume scanning when
required.
It is recommended that scanning is switched on when you are not
using the transceiver to communicate.
Switching scanning on or off
To switch scanning on or off:
1 Press SCAN.
If a call is not in progress, scanning is toggled on or off.
If a call is in progress, the call is ended and the transceiver
begins scanning.
NOTE: When scanning is switched on, mute is
also switched on.
NOTE: If you press PTT while the transceiver is
scanning, the scan is stopped.
To Next Page
Loading...
Need help?
General
