USING THE WIZARD
USING THE WIZARD
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 15
1 Press (Yes) to confirm that you want to start the
wizard.
If you want to bypass the wizard, press (No).
Selecting a language
NOTE: This step in the wizard is shown if you have
multiple languages available.
To select a language:
1 Press or to scroll to the language that you want to use
on the control point, then press (Select).
1 Press (Yes) to confirm that you want to change to the
selected language.
Setting the time and date
To set the time and date:
1 Press or to select the time zone that you want to use.
1 Press to move to the Daylight Saving entry.
1 Press or to select the time that you want to use.
1 Press to move to the Local Time entry.
1 Press to enter edit mode for the local time.
1 Press or to scroll to the value that you want to set, then
press to move to the next item.
1 Repeat this for minutes, seconds and AM/PM values.
1 Press (Save) to save the local time.
1 Press to move to the Local Date entry.
1 Press to enter edit mode for the local date.
To Next Page
Loading...
Need help?
General
