USING THE WIZARD
USING THE WIZARD
16 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
1 Press or to scroll to the value that you want to set, then
press to move to the next item.
1 Repeat this for the day/month and year, as required.
1 Press (Save) to save the local date.
1 Press to move to the Clock entry.
1 Press or to select the type of clock that you want to use.
1 Press to move to the Time Format entry.
1 Press or to select the format that you want to use.
1 Press to move to the Date Format entry.
1 Press or to select the format that you want to use.
1 If you want to review the information that you have entered,
press or to move through the entries.
1 Press (Save) to save the information.
If you have not changed any of the time and date
information, press (Close).
Setting the location of the desk console
NOTE: This step in the wizard in shown if your control
point is a desk console.
To set the location of the desk console:
1 Press or to scroll through the following values:
• If the desk console is connected directly to the
transceiver, select Local.
• If the desk console is connected to the transceiver
remotely, select Remote.
1 Press (Save) to save the location of the desk console.
To Next Page
Loading...
Need help?
General
