USING THE WIZARD
USING THE WIZARD
ENVOY™ TRANSCEIVER GETTING STARTED GUIDE 17
Adding a channel
NOTE: This step in the wizard is shown if you are
permitted to add channels.
To add a channel:
1 Press (Yes) to add a channel, if required.
1 Enter the name that you want to use for the channel, then
press to move to the Tx entry.
1 Enter the transmit frequency (in kHz) that you want to use
for this channel, then press to move to the Rx entry.
The Rx entry is automatically filled with the transmit
frequency.
1 Enter the receive frequency (in kHz), if required to be
different from the Tx frequency, then press to move to
the Mode entry.
1 To select a mode:
• Press to view the list of available modes.
• Press to scroll down through the list, and
press OK to select the highlighted mode.
The check box contains a when the mode is
selected.
•Press (Save).
1 If you want to review the information that you have entered,
press or to move through the entries.
1 Press (Save) to save the information.
1 Do one of the following:
• If you want to add another channel, press
(Yes), then repeat these steps.
• If you do not want to add another channel,
press (No).
To Next Page
Loading...
Need help?
General
