USING THE WIZARD
USING THE WIZARD
18 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
1 Do one of the following:
• If you want to add a scan table, press (Yes).
• If you do not want to add a scan table, press
(No), then continue from Entering a self address on
page 19.
1 Do one of the following:
• If you want to scan all of the channels in the
transceiver that have a USB mode, press
(Yes), then continue from Entering a self address on
page 19.
• If you want to choose the channels and modes that
you want to scan, press (No), then continue
from Adding channels to a scan table on page 18.
Adding channels to a scan table
When you are adding or editing a scan table, you may want to add
extra scan channels to those already in the scan table. When you use
the Add Chan option, you view a list of the channels in the
transceiver that have not yet been added to the scan table that you
are currently viewing.
To add channels to a scan table:
1 From the main menu, select (User Data), then
(Scan Tables).
1 Press to scroll to the scan table in which you want to add
a channel, then press OK.
1 Press to move to the Scan Channels entry.
1 Press to view the list of channels that are already added
to the scan table.
1 Press (Options), scroll to Add Chan, then
press (Select).
1 Press to scroll down through the list, then press OK to
select the highlighted channel.
1 Press or to select the mode that you want to use.
To Next Page
Loading...
Need help?
General
