OPERATING THE TRANSCEIVER
MUTING THE TRANSCEIVER
54 ENVOY™ TRANSCEIVER GETTING STARTED GUIDE
Muting the transceiver
When the transceiver is set to a channel or is scanning channels,
and mute is switched off, you hear on-air signals on each channel.
If you do not want to listen to this, you can silence the transceiver
by switching mute on.
Mute automatically comes on when the transceiver starts scanning.
The transceiver listens for signals according to what is set in
Settings > Scan Mute.
If the scan is paused due to voice being detected, the length of time
that the transceiver holds the pause is set in Settings > Scan
Voice Max Pause and Scan Voice Extend. Scanning only
resumes automatically if the transceiver is set to start scanning after
a timeout period.
Switching mute on or off
To switch mute on or off:
1 Press (Mute) on the channel, scanning or free-tune
screens.
On the 2221, press (Options), scroll to Mute
On|Off, then press (Select).
The V or S in the title bar of the channel screen is
highlighted when mute is on.
To Next Page
Loading...
Need help?
General
