INSTALLING THE TRANSCEIVER
OVERVIEW OF MOBILE STATIONS
Envoy™ Transceiver Getting Started Guide 85
Connecting the control cable to an automatic tuning antenna
To connect the control cable to an antenna:
1 Connect the socket at the end of the cable into the plug at
the base of the antenna, then secure the locking ring tightly
into position.
1 Fit the plug at the opposite end of the cable into the socket
at the end of the lead from the RF unit.
Connecting the power supply
To connect the transceiver to the battery power supply:
1 If you are using a 24 V battery supply, connect the battery
to a 24 V to 12 V voltage regulator (Codan part number
15-00508).
1 Connect the power supply cable (Codan part number
08-03255) to the plug at the end of the 12 V cable lead from
the RF unit.
1 Route the power supply cable according to the instructions
supplied with the Vehicle Installation Kit (Codan part
number 15-00112).
1 Insert the 32 A fuse and holder in the power supply cable at
a convenient location, as close as possible to the battery
terminals.
1 Connect the power supply cable to the battery terminals,
black to negative, red to positive.
To Next Page
Loading...
Need help?
General
