ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
295
Setpoint group General Analog Inputs Related FW 1.9.0
Range [units] the range is defined by analog sensor curve
Default value
the value is defined by
analog sensor curve
Alternative config NO
Step the step is defined by analog sensor curve
Comm object 14992 Related applications AMF, MRS
Config level Standard
Setpoint visibility Visible only if the logical binary output AIN SWITCH04 (PAGE 554) is configured
Description
Threshold level for switching the binary output AIN SWITCH 18 (PAGE 629) off. The value is measured from
AIN SWITCH 04 (PAGE 625) analog input.
Image 8.55 General analog input 4 switch
Analog Switch 18 Off
6 back to List of setpoints
General Analog Input 19
Setpoint group General Analog Inputs Related FW 1.9.0
Range [units] the range is defined by analog sensor curve
Default value
the value is defined by
analog sensor curve
Alternative config NO
Step the step is defined by analog sensor curve
Comm object 9313 Related applications AMF, MRS
Config level Standard
Setpoint visibility Visible only if the logical analog input AIN PROT19 (PAGE 622) is configured
Description
Warning or history threshold level for AIN PROT19 (PAGE 622).
Note: These setpoints are used only if LAI AIN PROT19 (PAGE 622) is adjusted to required protection
type. Otherwise these setpoints are useless.
Analog Protection 19 Wrn
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65