ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
357
Setpoint group
CM-GPRS; CM-4G-
GPS
Related FW 1.9.0
Range [units] Valid IP address [-]
Default value [-] Alternative config NO
Step [-]
Comm object 24314 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint Internet Connection
(page 359)
Description
The setpoint is used to adjust the domain name server (DNS), which is needed to translate domain names in
email addresses and server names into correct IP addresses.
DNS IP Address
6 List of setpoints (page 170)
Setpoint group
CM-GPRS; CM-4G-
GPS
Related FW 1.9.0
Range [units] DISABLED / ENABLED [-]
Default value ENABLED Alternative config NO
Step [-]
Comm object 24273 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint Internet Connection
(page 359)
Description
This setpoint enable or disable AirGate connection via CM-GPRS or via CM-4G-GPS.
DISABLED: Only SMS are sent. Internet-enabled SIM card is not required. AirGate is not used.
ENABLED This mode uses the “AirGate” service. Internet-enabled SIM card must be used. The
AirGate server address is adjusted by the setpoint AirGate Address (page 384).
IMPORTANT: When this setpoint is changed the controller has to be restarted to apply
changes.
AirGate Connection
6 back to List of setpoints

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65