ComAp InteliLite AMF25 User Manual

InteliLite Global Guide
599
Image 8.188 Stop Solenoid 2
Note: If Additional running engine indications (page 117) went off during 5 s pause than Stop
Solenoid is not activated again otherwise stop solenoid is activated again.
6 Logical binary outputs alphabetically (page 539)
Related FW 1.9.0 Related applications AMF, MRS
Comm object 1249
Description
The binary output depends on measured generator active power. Power is compared with generator nominal
active power with use of hysteresis and with delay of switch 1 s.
When the measured active power is equal to or bigger than 5 % of Nominal Power (page 176) for 1 s then
the binary output is closed.
When the measured active power is equal to or lower than 3 % of Nominal Power (page 176) for 1 s then
the binary output is opened.
Supplying Load
6 back to Logical binary outputs alphabetically
Related FW 1.9.0 Related applications AMF, MRS
Comm object 1997
Description
This logical binary output is result of internal comparator which compares statistic values Running Hours
(page 471) and Pulse Counter 2 (page 470). Binary output is active when Running Hours (page 471) are
equal or higher than the Pulse Counter 2 (page 470).
Swap Start
6 back to Logical binary outputs alphabetically

ComAp InteliLite AMF25 Specifications

General

Inputs	8 binary inputs
Outputs	8 binary outputs
Power Supply	8-36 V DC
Communication	RS232, RS485
Operating Temperature	-20°C to +70°C
Supported Generators	Diesel, gas
Controller Type	Automatic Mains Failure Controller
Protection	IP65