InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
11.2.3.8 Setpoint: RS232(1)MdmIni
This setpoint can be used to add extra AT commands at the end of the
initialization sequence of the modem connected to the COM1 port. The
command can be entered with as well as without the "AT" prefix, are
separated with semicolon and maximal length is 31 characters.
The setpoint can't be modified via the IG-NT built-in terminal.
11.2.3.9 Setpoint: RS232(2)MdmIni
This setpoint can be used to add extra AT commands at the end of the
initialization sequence of the modem connected to the COM2 port. The
command can be entered with as well as without the "AT" prefix, are
separated with semicolon and maximal length is 31 characters.
The setpoint can't be modified via the IG-NT built-in terminal.
Using a modem at the COM2 port is not supported since the hardware
version 2.0. For modem use the COM1 port instead.
11.2.3.10 Setpoint: RS485(1) conv.
This setpoint selects function of the built-in RS485(1) converter.
To Next Page
Loading...