InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
IM-NT does not provide the AutoSwap functions for other
controllers.
At least one controller in the logical group has to be
selected as MASTER if some PriorityAuto Swapping
mode is enabled. Only the controller with lowest CAN
address becomes an active master, the other are ignored
by SLAVE controllers. The MASTER controller evaluates
the Priority changing for all other controllers in the group
and sends them the “forced” Priority values.
11.2.9.4 Setpoint: #SysAMFstrtDel
System start delay between input Sys start/stop closing and start of Power
Management System. When input Sys start/stop is controlled by mains
decoupling relay, this setpoint adjusts the delay among the mains failure and
the emergency start of the gen-sets. If the MCB feedback is closed, Power
management is started with 1s delay after the input Sys start/stop closing -
parallel operation with the mains.
NOTE:
# sign in the name of this setpoint marks that this setpoint is shared among
all controllers connected by CAN2 bus.
11.2.9.5 Setpoint: #SysAMFstopDel
System stop delay between input Sys start/stop opening and Power
Management System deactivation. When input Sys start/stop is controlled by
mains decoupling relay, this is a delay among the end of mains failure and
opening of GCB. If the MCB feedback is closed, gen-sets are unloaded to
mains prior to GCB opening.
NOTE:
# sign in the name of this setpoint marks that this setpoint is shared among
all controllers connected by CAN2 bus.
To Next Page
Loading...