ComAp InteliMains NT IM-NT-BB - Page 290

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
290
Description
The setpoint is used to specify the recipient address for the active calls -
channel 2. The content of the address must correspond to the selected alert
type (e.g. it must contain e-mail address if the alert type is e-mail). See the
chapter Alarm messaging for more details.
11.2.15.12 Setpoint: AcallCH4-Type
Group
Act. calls/SMS
Range [units]
[-]
Related FW
standard v3.1.0
Force value
possible
YES
Description
The setpoint is used to specify the alert type of the active calls - channel 4.
See the chapter Alarm messaging for more details.
11.2.15.13 Setpoint: AcallCH4-Addr
Group
Act. calls/SMS
Range [units]
[-]
Related FW
standard v3.1.0
Description
The setpoint is used to specify the recipient address for the active calls -
channel 4. The content of the address must correspond to the selected alert
type (e.g. it must contain e-mail address if the alert type is e-mail). See the
chapter Alarm messaging for more details.
11.2.15.14 Setpoint: AcallCH5-Type
Group
Act. calls/SMS
Range [units]
[-]
Related FW
standard v3.1.0
Force value
possible
YES
Description
The setpoint is used to specify the alert type of the active calls - channel 5.
See the chapter Alarm messaging for more details.