InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
11.2.15.15 Setpoint: AcallCH5-Addr
The setpoint is used to specify the recipient address for the active calls -
channel 5. The content of the address must correspond to the selected alert
type (e.g. it must contain e-mail address if the alert type is e-mail). See the
chapter Alarm messaging for more details.
11.2.15.16 Setpoint: NumberRings AA
This setpoint is used to adjust the number of rings after which the modem,
which is attached to he controller, answers the incoming call.
Number of rings prior to answering the modem connection from PC to
controller.
NOTE:
Any change of this setpoint is applied first after next switching the controller
or modem off and on or after disconnecting the modem from the controller
and connecting it back.
11.2.15.17 Setpoint: ActCallAttempt
This setpoint is used to adjust the maximum number of consequent attempts
to perform an active data call. The next attempt is performed 120s after the
previous unsuccessful attempt.
11.2.15.18 Setpoint: Acall+SMS lang
To Next Page
Loading...