ComAp InteliMains NT IM-NT-BB - Page 293

InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
293
11.2.16.3 Setpoint: #SummerTimeMod
Group
Date/Time
Range [units]
DISABLED, WINTER, SUMMER, WINTER-S, SUMMER-S [-]
Related FW
standard v3.1.0
Description
The setpoint is used to select the mode of automatic daylight saving time
change.
DISABLED
The automatic change to daylight saving time and back is
disabled.
WINTER
The automatic change is enabled, the current season is
winter and the controller is located in the northern
hemisphere.
SUMMER
The automatic change is enabled, the current season is
summer and the controller is located in the northern
hemisphere.
WINTER-S
The automatic change is enabled, the current season is
winter and the controller is located in the southern
hemisphere.
SUMMER-S
The automatic change is enabled, the current season is
summer and the controller is located in the southern
hemisphere.
NOTE:
# sign in the name of this setpoint marks that this setpoint is shared among
all controllers connected by CAN2 bus.
11.2.16.4 Setpoint: #Time
Group
Date/Time
Range [units]
[HH:MM:SS]
Related FW
standard v3.1.0
Description
The setpoint shows the current time from the internal RTC clock of the
controller and can be also used to readjust it.
NOTE:
If the controller is connected to other controllers via the CAN2 bus, the