InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
Bus voltage in phase L3.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Bus VT ratio.
12.1.2.5 Value: Bus V
Bus voltage. Average from all three phases.
NOTE:
The ratio between the voltage measured at the input terminals and the
displayed voltage is adjusted by the setpoint Bus VT ratio.
12.1.2.6 Value: Bus V L1-L2
Bus voltage phase L1 to L2.
12.1.2.7 Value: Bus V L2-L3
Bus voltage phase L2 to L3.
To Next Page
Loading...