InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
12.1.2.8 Value: Bus V L3-L1
Bus voltage phase L3 to L1.
12.1.2.9 Value: Bus V unbal
Bus voltage unbalance. The value is calculated as maximal difference of two
phase voltages at one moment and expressed in % of the bus nominal
voltage.
12.1.2.10 Value: I Aux
This value shows actual current measured at auxiliar terminals.
12.1.2.11 Value: Slip freq
Differential frequency between the bus and the mains.
12.1.2.12 Value: Angle
To Next Page
Loading...