InteliMains
NT
, SW version 3.2.0
InteliMains-NT-MCB-MGCB-3.2.0-Reference Guide.pdf, ©ComAp – April 2015
14.2.1.52 Binary output: MODES: Test mode
The output is closed while the controller is currently in TEST mode (either
switched by the mode selector on the front panel or by the input Remote
TEST).
14.2.1.53 Binary output: MODES: Off mode
The output is closed while the controller is currently in OFF mode (either
switched by the mode selector on the front panel or by the input Remote
OFF).
14.2.1.54 Binary output: MODES: Man mode
The output is closed while the controller is currently in MAN mode (either
switched by the mode selector on the front panel or by the input Remote
MAN).
14.2.1.55 Binary output: MODES: Aut mode
The output is closed while the controller is currently in AUT mode (either
switched by the mode selector on the front panel or by the input Remote
AUT).
14.2.1.56 Binary output: MODES: Test mode
The output is closed while the controller is currently in TEST mode (either
switched by the mode selector on the front panel or by the input Remote
TEST).
14.2.1.57 Binary output: MODES: Off mode
The output is closed while the controller is currently in OFF mode (either
switched by the mode selector on the front panel or by the input Remote
OFF).
To Next Page
Loading...