Error codes indicate any problems with the dispenser. These problems are indicated
to you by codes displayed on the screen.
After you have physically corrected a fault, you need to clear the fault message
displayed on the control panel before normal operation can resume.
NOTE: You should read and understand all safety precautions before operating or
maintaining the Compac CNG Dispenser.
NOTE: When fixing Compac CNG Dispenser faults, please follow the recommendations
in this manual. Otherwise you may injure yourself and void the warranty.
Loss of price in the
Dispenser.
If the dispenser is connected to a site Controller,
the price on the dispenser should be set to
0.00 and the pricing should be sent from the
Controller.
This procedure is outlined in the Hose Price
section.
If the dispenser is not connected to a site
Controller, the price must be set on the
dispenser.
This procedure outlined in Hose Price section.
Loss of hose number
in the Dispenser.
Check that the hose number has been set.
This procedure is outlined in the Hose Number
section.
Repower dispenser
If problem persists contact your service agent.
Re-power the dispenser.
If problem persists contact your service agent
Contact your service agent
Contact your service agent
The temperature
pressure interface
board is
disconnected or has
failed.
Contact your service agent
To Next Page
Loading...
Need help?
General
