Compac C5000

25.
K-Factor Settings
Overfill pressure
The Overfill pressure is the pressure that the dispenser will end the fill at. This setting is used
with the deb setting(time is seconds over the overfill pressure) to ajust the final fill pressure.
CNG Setting
The CNG setting is specific settings for the CNG application. These settings are currently under
development but will inculed the following:
• Fill mode i.e. Mech or electronic
• Number of pressure probes
• Number of banks
Currently the setting that are available are below
0PA
200.0
cng
0000000
Pressure Probe Settings
0-No Pressure probe
1-1 pressure probe
2-
2 pressure probe