If the parameter switch is continually depressed, the following menu to change the
pump number will appear. Each side must be numbered between 1-99.
NOTE: Entering a pump number 0 will disable the pump.to the pump controller
See Using the Dispenser Menus to edit these settings. Use the procedure for both side A
and B.
The unit price (PA) is used to calculate the total value of the quantity dispensed. The
unit price can be different on each side of a dual hose dispenser.
The unit price can be set at the dispenser or set remotely via a POS or controller
NOTE: If the unit price is not set Error 3 will be displayed and the dispenser will
not operate.
To set the unit price:
- Make sure that the dispenser is idle, with the nozzle in its holster.
- Press and release the Parameter switch until the required unit price is
displayed (PA).
- Enter in the unit price.
To Next Page
Loading...
Need help?
General
