Compac C5000 Service Manual

29.
K-Factor Settings
C Configuration Code
The C configuration code (C) changes the operation of the dispenser.
The configuration code has been factory set and should not be changed. If the memory
gets wiped you will need to re-enter it.
Pump settings
This sets the number of hoses setup in the C5000. After setting this setting the number
of settings in the parameter and the K-Factor switch will change.
Start fill mode
This sets how the fill is started. If the setting is set to 0, when the nozzle is lifted the
dispenser starts. If at any time the nozzle is hung the dispenser ends the fill. It the
setting is set to 4, when the start button is pushed momentarily the dispenser starts the
fill. To stop the fill manually when the dispenser is in this mode you have to push the
stop button.
0000402
Pump Settings
1 – Single
2 – Dual
Start fill mode
0
– Nozzle Switch
4 – Push to start

Compac C5000 Specifications

General

Brand	Compac
Model	C5000
Category	Control Unit
Language	English