The coalescing filters are designed to trap dirt, moisture, oil, and other debris that
may damage the valve seals.
Before you start, make sure you have:
- A seal kit - Part number FC-FIL-0001
▪ 1 x filter
▪ 1 x filter bowl O-ring seal
- O-ring lubricant
To remove the coalescing filter:
- Degas the dispenser.
- Drain the coalescing filters if they have not been drained already.
- Unscrew the filter bowl(s) with a spanner on the 22mm hex nut at the base of
the filter bowl.
- Remove the filter element.
- Clean all oil and dirt off the components with a clean cloth.
To install the new coalescing filter:
- Insert the new filter element and lubricated filter bowl O-ring seal.
CAUTION: O-rings that are subjected to natural gas at high pressure swell when
exposed to air. Once swollen, they cannot be reused and must be replaced.
To Next Page
Loading...
Need help?
General
