Before you start, obtain the following replacement parts
- Replacement Power Supply part number F-CP-C5K-PS
To remove the C5000 Power Supply:
- De-gas the dispenser.
- Switch off the power supply to the dispenser.
DANGER: Never remove any electrical components without first switching off
the power to the dispenser. Failure to turn off the power could result in an
electric shock.
- Remove the flameproof box lid to gain access to the C5000 power supply
board.
CAUTION: Take basic anti-static precautions by wearing a wristband with an
earth strap.
- Undo the screws that hold the earth bar in the Flameproof box, taking
care not to lose any of the spacers or other mounting hardware
- Undo the screws that hold the terminal board in the flame proof box and
remove the terminal board.
- Undo the screws that hold any coms or GPIO board into the C5000
processor board.
- Undo the screws that hold the C5000 processor board in the flameproof
box and remove the C5000 processor board.
- Undo the screws that hold the C5000 power supply board in the flame
proof box
- Carefully slide out the C5000 power supply board to gain access to the
plugs on the Com bus Cable that connects into the bottom PCB, and
unplug this.
Completely remove the C5000 power supply board.
To Next Page
Loading...
Need help?
General
