5-26 Removal and Replacement Procedures
5. Close the display.
6. Remove the remaining screw from the left display clutch and the two screws from
the right display clutch.
7. Lift the display assembly from the base enclosure.
Figure 5-24.
Removing the Display Assembly
Reverse the procedure to replace the display assembly.
CAUTION:
To avoid damaging the display, attach the ground cable before attaching the
display cables when replacing the display assembly.
Note:
Always replace the four loctite screws with the replacement screws supplied in the
service kit.
To Next Page
Loading...
Need help?
General