Troubleshooting 2-9
Exiting Computer Setup
1. Click
Exit.
2. Select one of the following Exit options:
■
Save—Saves the new settings and exits Computer Setup.
NOTE
: Some settings may not take effect until the computer is restarted.
■
Ignore—Exits Computer Setup and restores previous settings.
■
Cancel—Returns to Computer Setup.
Computer Checkup (TEST)
Computer Checkup (TEST) determines whether the various computer components and
devices are recognized by the computer and are functioning properly. You can display,
print, or save the information that Computer Checkup generates.
NOTE:
Compaq Utilities are intended for testing only Compaq-supplied components.
Testing of non-Compaq components may be inconclusive.
Running Computer Checkup (TEST)
1. Plug the computer into an external power source. A low battery condition can
interrupt the program.
2. Connect a printer if you want to print a log of error messages.
3. Turn on the external devices that you want to test.
4. Turn on or restart the computer.
5. Access Compaq Utilities by pressing
F10
when the blinking cursor appears in the
upper-right corner of the display.
6. Click Computer Checkup ⇒ View the Device List.
■
If the list of installed devices is correct, click
OK.
■
If the list is incorrect, ensure that any new devices are installed properly.
7. Select one of the following from the Test Option menu:
■
Quick Check Diagnostics
■
Automatic Diagnostics
■
Prompted Diagnostics
8. Follow the instructions on the screen as the devices are tested.
9. Click Exit Diagnostics ⇒ Exit from this utility.
To Next Page
Loading...
Need help?
General