Removal and Replacement Procedures 5-5
MultiBay Devices
CAUTION:
The device in the MultiBay must be removed prior to performing
maintenance on the computer.
A diskette drive, an LS-120 diskette drive, a ZIP drive, a second battery pack, or a
second hard drive may be installed into the MultiBay.
The device in the MultiBay must be removed prior to performing maintenance on the
computer. For convenience, a diskette drive is depicted in this sequence. To remove any
MultiBay device, complete the following steps:
1. If applicable, remove the security screw from the bottom side of the computer (LS-
120 drive and ZIP drive only).
2. Press down on the release latch
1
and grasp the tab located on the underside of the
device.
3. Remove the device.
Figure 5-3.
Removing the MultiBay Device
To Next Page
Loading...
Need help?
General