Troubleshooting 2-11
Table 2-5
Memory Test Error Codes
Error Code Description Recommended Action
200-xx Memory machine ID test failed. The following steps apply to error codes 200-xx
and 202-xx:
202-xx Memory system CMOS checksum failed.
1. Flush the system CMOS and retest. See note.
2. Replace the system board and retest.
203-xx Write/Read test failed. The following applies to error codes 203-xx
through 215-xx:
204-xx Address test failed. Remove and replace the SODIMM memory board
or system board (if the memory on the system
board is faulty) and retest.
211-xx Random pattern test failed.
214-xx Noise test failed.
215-xx Random address test failed.
Table 2-6
Keyboard Test Error Codes
Error Code Description Recommended Action
300-xx Failed ID Test.
1. Reseat the keyboard assembly.
301-xx Failed Self test/Interface Test.
2. Replace the keyboard and retest.
302-xx Failed Individual Key Test.
3. Replace the system board and retest.
304-xx Failed Keyboard Repeat Test.
Table 2-7
Parallel Printer Test Error Codes
Error Code Description Recommended Action
401-xx Printer failed or not connected.
1. Connect the printer.
402-xx Failed Port Test.
2. Check power to the printer.
403-xx Printer pattern test failed.
3. Install the loopback connector and retest.
4. Check port and IRQ configuration.
5. Replace the system board and retest.
Note:
Fn + F11 clears the ESCD configuration information. If the Fn + F11 sequence is
pressed very early after powering the machine on (after you see the keyboard LEDs
blink, but before the video is initialized), CMOS memory will be invalidated. The
ESCD is cleared, the machine is reset and boots with the "162 - System Options Not
Set" message. This is a way to clear out configuration information, such as Windows
95's knowledge about a docking station. It may help clear up problems if the
configuration information had been corrupted. Timing of this keystroke sequence is
critical, as there is a very narrow window during which the keys will be recognized.
These keys are not documented to users.