Using an Internal Modem (Available on Select Models) 7-3
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: Beth Zanca Saved by: JAbercrombie Saved date: 07/13/99 1:34 PM
Part Number: 131511-001 File name: Ch07.doc
Using Modem Commands and Dial Modifiers
You can configure most communications software without the
use of AT commands or dial modifiers.
■ If you prefer to configure the modem using AT commands,
select StartÅProgramsÅAccessoriesÅHyperTerminal.
■ To access an AT command set including dial modifiers and
instructions, go to the Compaq Internet site at
http://www.compaq.com/support/portables.
Uninstalling the Modem
To uninstall the modem software and hardware under
Windows NT 4.0, you must log into Windows NT 4.0 with
Administrator privileges. To uninstall the modem software and
hardware under Windows 95, Windows 98, or Windows NT 4.0:
1. Click StartÅSettingsÅControl Panel.
2. Double-click the Add/Remove Programs icon.
3. Select the Compaq internal model from the list of software.
4. Click the Add/Remove button.
5. Click Yes to confirm.
6. If you are prompted to restart the system, click Yes.
Remove the modem hardware from the computer.
Using the Modem While Traveling
Internationally
Using a Country-Specific Modem Adapter
Telephone jacks vary by country. The modem cable included with
the computer plugs directly into an RJ-11 telephone jack. To plug
the modem cable into a different type of telephone jack, you must
use a country-specific modem cable adapter. A cable adapter is
provided with the computer. To obtain the country-specific
adapters required for your itinerary, refer to Appendix A to
contact a Compaq-authorized dealer, reseller, or service provider.
To Next Page
Loading...
Need help?
General
