7-6 Using an Internal Modem (Available on Select Models)
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: Beth Zanca Saved by: JAbercrombie Saved date: 07/13/99 1:34 PM
Part Number: 131511-001 File name: Ch07.doc
■ Set the modem to ignore dial tones—If the modem receives a
dial tone it does not recognize, it will not dial and will display
a No Dial Tone error message. To set the modem to ignore all
dial tones before dialing:
1. Select StartÅSettingsÅControl PanelÅModems.
2. Select your modem, then select PropertiesÅConnections
tab, then clear the Wait for Dial Tone Before Dialing check
box.
NOTE: If you continue to receive the No Dial Tone error
message after clearing the checkbox, click StartÅSettingsÅ
Control PanelÅDialing PropertiesÅselect USA in the “I am
in:” drop-down box, then again clear the Wait for Dial Tone
Before Dialing check box.
To Next Page
Loading...
