9-2 Using PC Cards
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: Beth Zanca Saved by: J Abercrombie Saved date: 07/01/99 11:04 AM
Part Number: 131511-001 File name: Ch09.doc
2. With the label side up, insert the 68-pin connector side of the
PC Card into the PC Card slot, pushing gently until firmly
seated.
CAUTION: To prevent damage to the connectors, use minimal
pressure when inserting a PC Card into a PC Card slot.
If you are running Windows 95 or Windows 98 and your
computer is on, the computer automatically configures a plug and
play card and most other PC Cards. If the computer is turned off
or in Suspend, a card is not configured until you turn on the
computer or exit Suspend.
Windows NT 4.0 is not a plug and play operating system at this
time. If you are running Windows NT 4.0, the computer
configures a card only when it is on at the time the PC Card is
inserted into the PC Card slot. The computer only recognizes that
a PC Card has been removed if the PC Card slot is empty when
the computer is powered on or the PC Card slot is empty at
startup.
After the computer has configured the card, the computer beeps
twice to indicate that the card is ready for use.
IMPORTANT: After the PC Card has been inserted and configured, it
may be necessary to perform an initial setup procedure. For
example, a new storage card may need to be formatted, or a new
network card may need drivers installed. For detailed information
on setup procedures for various network PC Cards, refer to the
instructions provided by the PC Card manufacturer.
To Next Page
Loading...
Need help?
General
