Comtech EF Data LPOD PS 1.5 - Page 134

Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
Revision 15
Serial Interface Operation 5–14 MN-LPOD
Parameter
Type
(* indicates
End-of-Life)
Controller-to-Target
Instruction Code and
Qualifier
Arguments
for Command
or Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of
Arguments)
Command Query
Response to
Command
Response
to Query
Concise Alarm
Status
N/A
CAS?
44 bytes
Query only.
Returns the alarm status of the unit, response is semicolon-delimited.
EXAMPLE: <1/CAS?{CR}
>0001/CAS=a;b;c;d;e;f;g;h;i;j;k;I;m;n;o;p;q;r;s;t;u;v;w;x;y;{CR}{LF} where:
a thru z where 0=FT, 1=OK, 2=AL, 3=NO, 4=YS, 5=MS, 6=??, or 7=NA (SEE
NOTES 2 AND 3)
a=+24V Power Supply
b=+24V Switch Power Supply
c=+13/18V LNB Power Supply (SEE NOTE 4)
d=+13.5V Power Supply
e=+10V Power Supply
f=+10V1 Amplifier Power Supply
g=+10V2 Amplifier Power Supply (SEE NOTE 4)
h=+7.8V Power Supply
i=+5.8V Power Supply
j=+2.5V Power Supply
k=+1.2V Power Supply
l=-5.8V Power Supply
m=Fan#1 State
n=Fan#2 State (SEE NOTE 4)
o=Heatsink Temp
p=Overtemp Shutdown
q=llC Status
r=Forward Power Alarm
s=Flash Checksum
t=FPGA Done
u=BUC Lock Detect (SEE NOTE 4)
v=External Ref Lock Detect (SEE NOTE 4)
w=LNB Current (SEE NOTE 4)
x=Redundancy Switch Condition (SEE NOTE 4)
CAS=
CAS=a;...z